AeroShell Turbine Oil 2
AeroShell Turbine Oil 2 is a 2 mm虏/s mineral turbine engine oil, blended from mineral base stocks, enhanced with a pour-point depressant and an anti-oxidant.
Specifications & approvals
| Country / OEM | Specification |
|---|---|
| United States | MIL-PRF-6081E Grade 1010 & 1010N |
| French | AIR 3516/A |
| Russian | MK-8 analogue |
| NATO Code | O-133 |
| Joint Service Designation | OM-10 (Obsolete) |
| Rolls-Royce | OMat 1024A |
The TDS and MSDS are in English, but you can find these documents for other countries in the .
Applications
AeroShell Turbine Oil 2 is widely used for inhibiting fuel systems and fuel system components during storage.
AeroShell Turbine Oil 2 is an analogue to the Russian Grade MK-8 and can therefore be used in engines which require the use of MK-8.
Health, Safety and Environment
Health and Safety
- This product is unlikely to present any significant health or safety hazard when properly used in the recommended application and good standards of personal hygiene are maintained.
- Avoid contact with skin. Use impervious gloves with used oil. After skin contact, wash immediately with soap and water.
- Guidance on Health and Safety is available on the appropriate Safety Data Sheet, which can be obtained from
Protect the Environment
- Take used oil to an authorised collection point. Do not discharge into drains, soil or water.
Additional information
Advice
- Advice on applications not covered here may be obtained from your Shell representative.
Typical Physical Characteristics
| Properties | Method | MIL-PRF-6081E Grade 1010/N | Typical |
|---|---|---|---|
| Oil type | - | Mineral | Mineral |
| Colour | ASTM D1500 | 5.5 max | <0.5 |
| Density @15.6掳C kg/m鲁 | ASTM D4052 | - | 878 |
| Kinematic Viscosity @37.8掳C mm虏/s | ASTM D445 | 10.0 min | 10.2 |
| Kinematic Viscosity @-40掳C mm虏/s | ASTM D2532 | 3 000 max | 2 305 |
| Viscosity stability 3hrs @-40掳C % | ASTM D2532 | 2 max | 0.5 |
| Pour Point 掳C | ASTM D97 | -57 max | <-57 |
| Flash Point 掳C | ASTM D92 | 132 min | 142 |
| Total Acid Number mgKOH/g | ASTM D664/974 | 0.10 max | 0.04 |
| Copper corrosion 3 hrs @100掳C | ASTM D130 | 1 max | Passes |
| Trace sediment ml/200ml | ASTM D2273 | 0.005 max | <0.005 |
| Corrosion and oxidation stability 168 hrs - metal weight change @121掳C, mg/cm虏 | ASTM D4636 | Must pass | Passes |
| Corrosion and oxidation stability 168 hrs - change in viscosity @121掳C, % | ASTM D4636 | -5 to +20 | Passes |
| Corrosion and oxidation stability 168 hrs - acid number change @121掳C, mgKOH/g | ASTM D4636 | 0.2 max | <0.2 |
These characteristics are typical of current production. Whilst future production will conform to Shell's specification, variations in these characteristics may occur.
